November Manufacturing Update

Happy November, backers!

Here’s our latest update. In the October update, we only showed you the plastic molding pieces.  Below, you will also see the metal molding pieces.  First iteration was good but not good enough.  We need to do a few more rounds of adjustments to the tooling to make sure it comes out great.  

The KitKat update is almost done.  Once we test it thoroughly, we will go ahead with printing the PCB board and mounting all the components. This is the most critical part for us now.  All the operating system, chip and component specs are done.  Hopefully, the last round of performance testing comes out well, so we can move on with the mass assembly!

Alex and Omar

ODIN being assembled

ODIN being assembled

Close-up of ODIN with its top off!

Close-up of ODIN with its top off!

Views of ODIN’s left and right side

Views of ODIN’s left and right side

Our base that makes watching on your ceiling possible

Our base that makes watching on your ceiling possible

A fully assembled ODIN! See how portable it is!

A fully assembled ODIN! See how portable it is!

ODIN standing at attention

ODIN standing at attention